玩raspberry pi camera模块。太mini了。。我一使劲。就把排线给拔出来了。。。然后插好排线。就提示
“mmal: mmal_vc_component_create: failed to create component ‘vc.ril.camera’ (1:ENOMEM)”
Camera not working at all
Example error message: “mmal: mmal_vc_component_create: failed to create component ‘vc.ril.camera’ (1:ENOMEM)”
Make sure the flex cable is inserted the correct way on both ends, and each connector has the locking tab engaged. The RPi + camera draws about 260 mA more current when recording video, than without the camera. The Model B is about 550 mA by itself, so camera use pushes it over 800 mA. Some power supplies, cables, and polyfuses may not maintain 5V onboard at this current load well enough for reliable operation. You can check this with a voltmeter across TP1 and TP2.
In some cases, the micro-connector from the camera module to the camera board PCB has been loose. This can be fixed by removing and re-seating the small (tiny!) yellow flex cable connector labelled “P5V04A SUNNY” on the camera board. It makes a click when it is fully seated.